Sunday, January 22, 2012

Welding Caps Instructions again



I told you last time I would get together instructions for you and I had an awful time trying to get the pattern where you can just print it out. The best I can do is direct you to 2010 posts where I gave you the directions as well as the pictures of the pattern.
I am sorry about it but I am not tech savvy enough to to it any other way.
If some time in the future I figure it out, I'll post it.

Until then here are the pattern pieces and I"ll try to walk you through this.

You will need 4 fat quarters or about 18" of two co ordinating fabrics. Cotton works best.

You will need to cut 2 fronts, 2 backs, 2 side panels, 2 bills and 1 bill piece from felt or fleece and 2 strips for the cap band measuring about 34 -36 inches.

Hopefully you have sewing experience. Sew the bill together using 3 pieces 1 for the outside,the felt or fleece for the padding and 1 for the inside of cap.

* I make mine so they are reversible, Using 1 design on the outside and another design for the inside. After you sew the bill together you then treat the rest of the sewing like you are working on just 1 cap (You will see why in a mionute)

I sew a front and a back to the side panel and do it again then sew the 2 sections together matching up edges. I pin the finished bill piece to the edge of the front pieces then I sew the band to the lower edge around the whole cap. You will need to do some adaptations when you get near the end so the band will need to be sized up and trimmed as you finish it.

Npw do this again for your inside cap.

You will then do the exact same steps for the inside of cap.

Second to the Last step: Place the inside and outside caps together right sides touching And sew around the whole thing leaving a couple inches open for turning.

Turn the cap outside right through the opening and do a stay stitch around the whole cap.

Done.


In the mean time if you can print it and work with it let me know how you did, I would love to see pictures.


Here's a tip, if you have an old baseball hat laying around try looking at it to see how it's put together. You could even tear it up and work with it as a pattern.

I hope this tut helps, I'm sorry it's the best I could give you for now.
Until next time happy crafting peoples.

4 comments:

  1. Thanks for posting this pattern.....just one question......how wide do you cut the strips?
    Thanks...bopeep

    ReplyDelete
  2. A pipe welder is someone who specializes on metal pipes. He or she uses heat to mold and connect these pipes together. The mean annual pipe welder salary is around $36,630, which means that they earn $17.61 per hour. The highest division of pipe welders has a yearly pay check of $52,420 while the lowest division gets $28,300. Average Wage of Welder

    ReplyDelete
    Replies
    1. UA Journeyman earn over $40 an hour on the west coast.

      Delete
  3. This comment has been removed by the author.

    ReplyDelete